RECON RSS DRONE
04-10-2009, 11:10 AM
We have posted a new interim release of firmware (Build 18 v3.6.4) at www.red.com/support (http://www.red.com/support) to address the following issues.
* Eliminated camera "stall" during boot up sequence.
* Eliminated requirement to wait 10 seconds between power down / power up.
* Eliminated "blue screen" LCD / EVF symptom following camera re-boot.
* Eliminated camera "menu lock up" when connected to a consumer HDTV set via HDMI cable.
In addition we made the following operational changes -
* Modified Time-Lapse default setting to Interval (was One-Shot)
* Modified GPI B default setting to Record (was Time-Lapse record)
* Modified Audio 1 and 2 default assignment to Line Level.
* Modified audio PPM scaling and Witness Mark for 0dBu / - 20dBFS reference level.
* Modified Phantom Power logic to remain enabled across camera power cycles ( Rev B Audio hardware only)
As this is a Beta test build, the usual disclaimer about using appropriate caution on commercial jobs applies.
Please send back any comments via e-mail to Red Technical Support.
Jim
More... (http://www.reduser.net/forum/showthread.php?t=28804&goto=newpost)
* Eliminated camera "stall" during boot up sequence.
* Eliminated requirement to wait 10 seconds between power down / power up.
* Eliminated "blue screen" LCD / EVF symptom following camera re-boot.
* Eliminated camera "menu lock up" when connected to a consumer HDTV set via HDMI cable.
In addition we made the following operational changes -
* Modified Time-Lapse default setting to Interval (was One-Shot)
* Modified GPI B default setting to Record (was Time-Lapse record)
* Modified Audio 1 and 2 default assignment to Line Level.
* Modified audio PPM scaling and Witness Mark for 0dBu / - 20dBFS reference level.
* Modified Phantom Power logic to remain enabled across camera power cycles ( Rev B Audio hardware only)
As this is a Beta test build, the usual disclaimer about using appropriate caution on commercial jobs applies.
Please send back any comments via e-mail to Red Technical Support.
Jim
More... (http://www.reduser.net/forum/showthread.php?t=28804&goto=newpost)